Trusted Blown-In Insulation for North Las Vegas Homeowners
If your North Las Vegas home feels hot by 10 a.m. in July and your upstairs rooms never quite cool down, the attic floor is usually the culprit. Blown-in insulation is the standard fix for older attics with settled or missing material, and in North Las Vegas it typically runs $1,400 to $3,600 installed, depending on square footage, target R-value, and how much air sealing the attic floor needs first.
Our technicians have up to 10 years of experience, and every blown-in job starts with a written price and ends with a Documented Photo Record. We don’t blow insulation over an unsealed attic floor; air sealing comes first, then insulation, in that order. On applicable jobs we also publish before-and-after blower-door numbers so you can see the actual air-loss change you paid for. Calls are answered by a live person 24/7, and same-day estimates are often available in North Las Vegas – call (833) 630-4008 to get one scheduled.
What Our Blown-In Insulation Service Includes
Blown-in insulation is loose material – cellulose or fiberglass – machine-puffed into your attic or wall cavities to a measured depth. It’s the go-to choice for existing homes because it fills around pipes, wires, and irregular framing that batt insulation can’t wrap. Here are the four versions we install in North Las Vegas.
Blown-In Cellulose
Cellulose is recycled paper fiber treated with fire retardant, and it’s the material we install most often in North Las Vegas attics because it packs tightly and slows air movement better than fiberglass at the same depth. You want cellulose when your attic floor has settled, has bare patches, or has never been topped up since the home was built. We source from GreenFiber, measure the installed depth in inches against the target R-value for our climate zone, and leave you the bag count and depth on the written record.
Blown-In Fiberglass
Fiberglass is lighter, doesn’t absorb moisture the way cellulose can, and is the practical pick when an attic has had past leaks or a swamp cooler setup that left damp framing. It’s also easier to work with around heat-producing fixtures if you plan to add recessed lighting later. We install fiberglass from Owens Corning and Johns Manville, blown to the depth your R-value target requires, and we flag any wet spots before a single bag goes in.
Dense-Pack Wall Insulation
Dense-pack is blown-in insulation packed into wall cavities at higher density through small holes drilled from the exterior or interior, then patched. You need it when your North Las Vegas home was built before wall insulation was standard, or when you can feel a wall that’s warm on one side and cool on the other. We use a density gauge during install to confirm each cavity is actually filled and not just bridged, and we photograph the drill points and patches before we close them.
Blown-In Top-Up
A top-up means adding insulation on top of what’s already there to reach a higher R-value, and it’s the cheapest performance gain most North Las Vegas homes can get. You need one when your attic has some insulation but it’s below the recommended depth for our climate, which is common in homes built between 2005 and 2015. Before we top up, we air seal the attic floor – top plates, can lights, and penetrations – because adding insulation over unsealed gaps wastes most of what you just paid for.
Brands We Service for Blown-In Insulation

We install blown-in cellulose from GreenFiber and fiberglass from Owens Corning and Johns Manville, and we also handle Rockwool and CertainTeed products when a homeowner already has them in the attic or prefers them for a specific reason. Each material behaves differently in North Las Vegas’s dry heat and seasonal dust: cellulose settles predictably, fiberglass holds its loft but needs careful coverage around penetrations, and CertainTeed’s fiberglass lines are consistent bag to bag for depth measurement. We know where each one performs and where it underperforms in this climate, and we’ll tell you which one makes sense for your attic rather than defaulting to a single product.
We also work with Icynene and Demilec spray foam products for the transition areas – rim joists, knee walls, and attic hatches – where blown-in material alone can’t seal the gap. No proprietary product lock-in here; we source from multiple manufacturers so you’re not stuck with one brand’s pricing. Whether you have GreenFiber cellulose in the attic now, CertainTeed fiberglass around the ducts, or any other make, we can help.
Signs You Need Blown-In Insulation Right Now
- Your upstairs rooms are 5 to 10 degrees hotter than downstairs. That gap usually means the attic floor isn’t holding heat out, and North Las Vegas summers make it obvious by June. If a ceiling feels warm to the touch at noon, the insulation below it is either thin, settled, or missing.
- You can see the ceiling joists in the attic. If you can look across the attic floor and see wood, the insulation has settled below the joist line or was never brought to depth. That’s a straight replacement or top-up situation, and it’s one of the fastest paybacks in home performance.
- Your energy bill jumped without a rate change. A 15-20% swing between one summer and the next with no new appliance and no rate increase usually points to lost attic insulation or new air leaks. We measure both with a blower-door test before recommending anything.
- Your HVAC runs nonstop and still doesn’t satisfy the thermostat. A system that can’t reach setpoint is often fighting a leaky, under-insulated envelope. More insulation alone won’t fix a duct problem, so we check both before quoting.
- You’ve had rodents, roof leaks, or a swamp cooler removed. Rodent tunneling compresses insulation, water ruins it, and removing a swamp cooler leaves a void. In each case the old material should come out before new material goes in, and we handle removal as part of the same job.
Our Blown-In Insulation Process – Step by Step

- 1
Written price and written scope, before any work starts. We inspect the attic, measure existing insulation depth, and check for moisture, pests, and air leaks. You get a flat price with the R-value target, the material, and the depth spelled out in writing. Nothing begins until you have that document in hand.
- 2
Air sealing first. We seal top plates, can lights, plumbing penetrations, and the attic hatch with caulk, foam, and rigid baffles. This is the step most companies skip, and it’s the one that determines whether your insulation actually works. Skipping it is like putting on a coat with the zipper open.
- 3
Blower-door test. A blower-door test is a pressurization reading that shows, in one number, how much air your building envelope is losing. We take a before-sealing reading and an after reading, and both numbers go on your record. A typical North Las Vegas home reads around 4,500 to 6,000 CFM50 before we start.
- 4
Blow the insulation to measured depth. We mark depth gauges on the joists so the crew can confirm coverage in every bay, then blow the material to the target depth. Fiberglass gets blown with a machine that fluffs it correctly; cellulose gets packed so it doesn’t settle below spec. Both get measured, not eyeballed.
- 5
Photo record and warranty at close-out. We photograph the attic before, after sealing, and after insulation, and deliver the image set with the depth readings and warranty document. If anything is off in the first 365 days, the Done Right Promise covers a return visit at no charge.
How Much Does Blown-In Insulation Cost in North Las Vegas?
A typical blown-in cellulose job in a 1,500-square-foot North Las Vegas home runs $1,600 to $2,800, including air sealing of the attic floor and a blower-door reading before and after. A blown-in fiberglass top-up on a home that already has some insulation runs $1,200 to $2,100. Dense-pack wall insulation on a single exterior wall runs $1,400 to $2,400 depending on wall length and how many cavities need drilling and patching. Full replacement – removal of damaged or rodent-contaminated material plus new insulation – typically runs $2,800 to $4,600.
Three things move the price: the square footage of the attic, the R-value target you’re reaching for, and whether the old material has to come out first. Older North Las Vegas homes near downtown often have blown-in material that’s been tunneled through by rodents, which means removal is part of the job. Homes built in the 2010s usually just need a top-up and air sealing. To avoid overpaying, insist on a written scope that names the R-value target and material, get a second opinion on any quote you receive, and don’t accept a price that excludes air sealing – that’s usually where the “cheap” quote hides its gap.
A free estimate from us includes an attic inspection, depth measurement, a written R-value target, and a flat price. Bring us a competing written estimate and we’ll read it with you, free of charge, before you sign anything.
Blown-In Insulation Near North Las Vegas – Our Service Area

We serve North Las Vegas and the surrounding valley, including blown-in insulation in Sunrise Manor, Winchester, Whitney, and Las Vegas proper. Typical scheduling in North Las Vegas is within a few days, and estimates are often available same-day. For a broader look at the service across the metro, see our Las Vegas blown-in insulation page, or start at our home page to see the full envelope service line. If you’re in North Las Vegas or nearby, call (833) 630-4008 and we’ll get you on the schedule.
Serving North Las Vegas, NV – Our Local Coverage Area
We serve North Las Vegas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Blown-In Insulation in North Las Vegas

Blown-in insulation is loose cellulose or fiberglass material machine-puffed into an attic or wall cavity to a measured depth, filling around pipes, wires, and framing that batts can’t reach. It’s the standard retrofit for existing homes because it works with the structure you already have. In North Las Vegas, we blow cellulose or fiberglass to the R-value target for this climate zone and measure depth in inches before we close out the job. Call (833) 630-4008 to talk through which material fits your attic.
Most attic blown-in jobs in North Las Vegas finish in a single day, usually 4 to 6 hours for a 1,500-square-foot attic including air sealing and the blower-door test. Larger attics, full removal of old material, or dense-pack wall work can push a job into two days. We give you the expected duration in the written scope before anyone starts, so you know how long the crew will be on site. Call (833) 630-4008 for a scheduling window.
Blown-in insulation in North Las Vegas typically runs $1,200 to $4,600 depending on scope: a fiberglass top-up starts around $1,200, a full cellulose install with air sealing runs $1,600 to $2,800, and full removal plus replacement runs $2,800 to $4,600. The R-value target, attic square footage, and whether old material needs removal are the three biggest price drivers. Call (833) 630-4008 for an exact written quote – estimates are free, and we’ll read any competing estimate with you.
Yes – we work with Rockwool, CertainTeed, Icynene, and Demilec, plus GreenFiber cellulose and Owens Corning and Johns Manville fiberglass. Each material has a place: Rockwool and CertainTeed fiberglass for attics that need moisture tolerance, Icynene and Demilec for the rim joist and transition areas where blown-in material can’t seal the gap. We don’t lock you into a single manufacturer, and we’ll tell you when a brand you asked about isn’t the right fit for your attic. Call (833) 630-4008 to talk through options.
Same-day estimates in North Las Vegas are often available, and calls are answered by a live person 24/7 – no voicemail loop, no callback window measured in business days. If you’re dealing with an active leak, rodent damage, or a failed attic hatch, we’ll prioritize the visit and tell you honestly what can wait. Call (833) 630-4008 and we’ll give you a real scheduling window.
Our 365-Day Done Right Promise covers your blown-in insulation job for a full year – if it’s not done right, we make it right. That’s backed by a written scope and written warranty you receive before any work begins, plus a Documented Photo Record of the attic before, during, and after the job. If the installed depth doesn’t match the spec, that’s on us. Call (833) 630-4008 with any warranty question.
Clear the attic access and any vehicles from the driveway, and make sure someone over 18 is home to sign off on the written scope. If you have pets, keep them in a closed room away from the attic hatch during the visit. We handle the drop cloths, the sealing, and the clean-up – you don’t need to move anything out of the attic. Call (833) 630-4008 if you have a specific setup we should know about before we arrive.
Schedule Your Blown-In Insulation Service in North Las Vegas Today
If your North Las Vegas attic is under-insulated, sealed poorly, or both, we can fix it in a single visit with a written price in hand before we start. You’ll get a flat quote, air sealing before insulation, before-and-after blower-door numbers, a Documented Photo Record, and a 365-Day Done Right Promise. Call (833) 630-4008 for a free, no-obligation estimate – calls are answered by a live person 24/7, and same-day estimates are often available.
Written by the team at Envelope Insulation Co.