Reflectix Radiant Barrier Installation in North Las Vegas: What to Know First
Reflectix radiant barrier installation in North Las Vegas usually takes one day for a standard attic and runs $1,600 – $3,400 for most homes, depending on square footage, whether existing foil has to come down, and how much air sealing the attic floor needs first. We’re an independent Reflectix service provider, not the manufacturer, and we publish a written price before any work starts, so you know the number before a tech touches your attic. On applicable jobs we also give you before-and-after blower-door readings – a pressurization measurement that shows, in one figure, how much conditioned air your home was losing.
This page is for North Las Vegas homeowners who already have a Reflectix product – attic foil, roof-deck barrier, or a roll of Radiant Barrier foil in the garage – and need it installed or replaced correctly. Call (833) 630-4008 and a live person answers.
How Reflectix Products Fail – and How We Fix Them
Radiant barrier jobs in North Las Vegas fail in predictable ways, and most of them have nothing to do with the foil itself. Here’s what we actually find on Reflectix jobs and what we do about it.
- Reflectix Double Reflective foil sagging off the rafters. Stapled to rafters with the wrong spacing, the foil sags within a couple of Vegas summers, and a sagging barrier loses the air gap that makes it work. We re-tension and re-staple to the deck, or lay it flat over the attic floor joists where the gap can actually hold.
- Foil burned through or degraded at the roof deck. North Las Vegas attic temperatures routinely hit 150°F and higher in July, and foil stapled tight against hot sheathing cooks. The material isn’t defective – the installation was. We set the barrier with a proper air gap or move to a foil-faced roof-deck barrier rated for the radiant heat load.
- Condensation stains on the underside of the foil. On homes with an unsealed attic floor, warm moist air rises into the attic and condenses on the foil’s cool side. This is an air-sealing problem, not a Reflectix problem. We seal the top plates, can lights, and penetrations first, then install the barrier. Never the other way around.
- Radiant Barrier foil crushed over the joists. Foil rolled flat and walked on during later HVAC work loses most of its reflectivity from dust and contact. We pull and reset crushed sections and flag the cause so it doesn’t repeat.
- Tape-and-pray seams coming apart. Reflectix seams taped with general-purpose tape fail at the first hot season. We re-tape with foil-rated seam tape and seal the perimeter so hot attic air doesn’t bypass the barrier.
One local reality worth writing down: in North Las Vegas, homes built during the 2004 – 2008 boom often have attic decking that was re-roofed once already, and the original foil was stapled to the old sheathing. When we replace the barrier, we inspect the re-roof line before we touch the new foil – if the sheathing was overlaid, the barrier needs to attach to the current deck, not the old one.
Our Reflectix Radiant Barrier Installation Process

- 1
Call and attic inspection. A live person answers 24/7. We schedule a visit, send a named technician, and text you when they’re on the way. The tech inspects your Reflectix product – attic foil, roof-deck barrier, or a stored roll – and measures the attic: square footage, decking, ventilation, and whether the floor is sealed.
- 2
Written price before any work starts. Haven Standard Clause 1: flat price, written scope, written warranty before anyone lifts a tool. No surprises, no “we’ll see once we’re up there.”
- 3
Air sealing first, always. We seal top plates, can lights, and every penetration in the attic floor before any foil or insulation goes down. We will never install a radiant barrier over an unsealed attic floor.
- 4
Materials decision. On a Reflectix job we specify Reflectix-compatible foil or a foil-faced roof-deck barrier from Owens Corning, Johns Manville, or CertainTeed when the Reflectix product won’t hold up to the specific attic. We explain the trade-off in writing before you decide. No product lock-in.
- 5
Install the barrier, then blower-door test. Barrier set with the right air gap, seams taped with foil-rated tape. On applicable jobs we run a before-and-after blower-door test and give you both numbers.
- 6
Clean up and document. Attic swept, debris removed, and a Documented Photo Record of the finished work included on the visit – not on request. The 365-Day Done Right Promise covers everything we did.
What Reflectix Radiant Barrier Installation Costs in North Las Vegas
Here are the ranges most Reflectix radiant barrier jobs in North Las Vegas fall into. Your written price will be specific to your attic.
| Scope | Typical price range |
|---|---|
| Attic radiant barrier foil, standard single-story home (1,400 – 1,800 sq ft) | $1,600 – $2,400 |
| Attic radiant barrier foil, two-story or larger attic | $2,200 – $3,400 |
| Roof-deck radiant barrier over existing foil | $2,600 – $4,100 |
| Radiant barrier plus attic air sealing | add $600 – $1,800 |
| Radiant barrier plus attic ventilation correction | add $400 – $1,200 |
What moves the price: attic access (a scuttle versus a full pull-down), whether existing Reflectix has to be removed, how many penetrations need sealing, and the size of the home. Free second opinion on any written estimate you’ve already got – we’ll read it with you. Call (833) 630-4008 for a free estimate.
Why North Las Vegas Homeowners Call Envelope Insulation North Las Vegas for Reflectix Work

We’ve sealed and insulated 9,000+ homes since 2016, and every one of them got a written price before work started and a documented record when the crew left. Our technicians have up to 10 years of experience, including on Reflectix products specifically. Under the 365-Day Done Right Promise, if it’s not done right, we make it right. Calls are answered by a live person 24/7, our technicians are background-checked and uniformed, and we never use urgency theatre to push you into a decision.
We work with Reflectix and with the other major material brands – Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, Icynene, Demilec, and GreenFiber – so the right product gets specified for your attic, not the one a rep is pushing.
FAQs
As an independent Reflectix service provider, we install to the manufacturer’s spec so the material warranty stays intact – and we back the work itself under our own 365-Day Done Right Promise. If a seam or fastener fails within that year, we come back and fix it. Call (833) 630-4008 for details specific to your product.
Reflectix foil, roof-deck barrier, and seam tape are stocked through local supply chains, so most jobs don’t wait on a special order. If a specific Reflectix product needs a lead time, we’ll tell you the date in writing before you decide. Call (833) 630-4008 to check your product.
Repair is usually cheaper if the foil is intact and only the fastening or seams have failed – typically $300 – $800. Replace if the foil is crushed, burned through at the deck, or coated in dust from years of attic work. Most North Las Vegas homes we see in the 2004 – 2008 build window end up on the replace side. Call (833) 630-4008 for an exact quote – estimates are free.
Most North Las Vegas Reflectix jobs can be scheduled within the same week, and a standard attic is done in one day. We text you when the technician is on the way. Call (833) 630-4008 and a live person will get you on the schedule.
A properly installed radiant barrier can meaningfully reduce attic heat gain in a North Las Vegas summer, but the biggest savings usually come from air sealing the attic floor first. That’s why we do it in that order – and why you get blower-door numbers to see the result. Call (833) 630-4008 to book an inspection.
Written by the team at Envelope Insulation North Las Vegas, serving North Las Vegas and nearby areas.