Reflectix Attic Insulation in North Las Vegas: What to Know First
Reflectix attic insulation work in North Las Vegas is usually a one-day job, and most of what we quote costs between $1,900 and $5,400 depending on whether you’re topping up over an existing radiant barrier, replacing foil that has failed, or starting from a bare attic floor with a proper cap and baffles. Every Reflectix job starts with a written price and ends with a Documented Photo Record, and on jobs where air sealing is part of the scope you also leave with before-and-after blower-door readings – a pressurization measurement that shows, in one number, how much conditioned air the home was losing before and after.
We’re an independent Reflectix service provider, which means we work with Reflectix products the way a good mechanic works with Nissan: we know the parts, we’re not authorized by the manufacturer, and we’ll tell you plainly when a Reflectix product is the right answer and when it isn’t. This page is written for North Las Vegas homeowners who already have Reflectix in their attic – typically the radiant barrier foil sold at the big-box stores on North 5th and Decatur – and want insulation that actually performs in our climate. Call (833) 630-4008 and a live person picks up.
How Reflectix Products Fail – and How We Fix Them
The thing most people miss about Reflectix is that it’s a radiant barrier, not insulation in the R-value sense. The foil-polyethylene-foil bubble wrap sold as Reflextix Double Reflective Insulation (the 24-inch and 48-inch rolls) carries an R-value around R-3.7 to R-4.2 depending on install convention – meaningful as a radiant control layer, near-pointless as the only thing standing between your living room and 105°F attic air. In North Las Vegas, where attic temperatures hit 150°F on a July afternoon, that distinction decides your August power bill. Here’s what we find when we open attics with Reflectix already in them:
- Foil laid flat on the attic floor, not under the rafters. The most common install error we see in North Las Vegas is Reflectix stapled directly to the joists with fiberglass underneath. Flat against a surface, the foil conducts heat instead of reflecting it – a radiant barrier needs an air gap on the reflective face to work, and without one you’ve paid for a vapor retarder and gotten no radiant benefit. We lift the foil, verify the air gap, and re-hang it on the underside of the roof deck where it can do its actual job.
- Perforated vs. non-perforated roll confusion. Reflectix sells both perforated (for humid climates where you don’t want a vapor trap) and solid (for dry climates, better radiant performance). North Las Vegas is desert-dry, and solid foil is usually the right call for a radiant barrier, but we find perforated product stapled into attics all the time because it was the roll on the shelf. Perforation is fine, but it loses a meaningful share of its reflectivity; when we’re re-doing a Radiant Barrier Reflective Insulation install we specify solid and seal the seams with foil tape.
- Single-bubble “Reflectix Insulation” confused with Double Bubble. The two products look similar on a shelf tag and perform differently. Double Bubble (the two-air-layer version) is the one with a real radiant claim; single-bubble foil-poly is thinner, tears at staples, and in our heat turns brittle after a few summers at the peak. When we find torn single-bubble, we replace with Double Bubble where radiant control is the goal and add a proper R-38 to R-49 insulation layer on the attic floor to do the actual thermal work.
- Staples through seams and joints, not foil tape. Every staple puncture and untaped seam is a thermal leak in a radiant barrier. In a summer afternoon attic, a 1/8-inch gap at a seam is a hot spot you can feel. Our crews tape every seam with foil-backed tape (not duct tape – duct tape fails at attic temperatures) and staple through a batten, never through the reflective face where we can help it.
- Reflectix over old, wet, or rodent-damaged fiberglass. This is the one that ends up costing the most. We pull out more attics in North Las Vegas where Reflectix was stapled over fiberglass that had been urine-soaked by roof rats or compressed by blown-in top-ups, and the foil sealed the mess in. We won’t install new insulation over that. Removal, rodent proofing, sanitizing, and only then a fresh, correctly layered system is the only way it lasts.
Our Reflectix Attic Insulation Process

Here’s what a Reflectix job actually looks like from the first phone call to the last photo.
- 1
Attic inspection and air-seal survey (day one, in person). We photograph the existing Reflectix product, note the roll type and where it’s installed, measure existing R-value, and find the air leaks – top plates, can lights, plumbing penetrations, and the attic hatch. You get a written price before any work starts, under Haven Standard Clause 1.
- 2
Air sealing first, always. Every penetration gets sealed (foam, caulk, or a proper can-light cover rated for contact with insulation) before we add a single bag of insulation. We will not blow insulation over an unsealed attic floor, whether Reflectix is already in the attic or not – it’s the reason our blower-door numbers actually move.
- 3
The Reflectix decision. If your existing reflectix foil is intact, we lift and re-hang it correctly and specify a blown-in cap under it. If it’s degraded, we remove it, specify a solid radiant barrier replacement, and add the fiberglass or mineral wool cap. We’re not brand-locked: Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, Icynene, Demilec, and GreenFiber are all on our shelf, and we’ll tell you which one fits the job – not which one we’re trying to move.
- 4
Insulation install. Blown-in fiberglass or cellulose to R-38 to R-49 on the attic floor, or batt insulation where the framing calls for it, with baffles at the eaves so the roof can still vent. Radiant barrier goes on the underside of the rafters with the correct air gap.
- 5
Blower-door test and photo record. On applicable jobs we run a blower-door test before and after air sealing and publish the readings (for example: 4,300 CFM50 before sealing, 2,100 after). Every job closes with a Documented Photo Record – the before, the seal work, the installed product, the final reading, in one file you own.
- 6
Sixty-day walkthrough and the 365-Day Done Right Promise. If anything underperforms – a hot room, a draft at a bad seam, a photo you don’t like – we come back and make it right under the 365-Day Done Right Promise, backed by the written scope and written warranty you have in hand.
What Reflectix Attic Insulation Costs in North Las Vegas
Reflectix attic insulation work in North Las Vegas runs from a couple hundred dollars for a small radiant-barrier re-hang to over five thousand for a full remove-and-rebuild on a large attic. The ranges below reflect what we actually write on quotes in North Las Vegas, not national averages:
| Scope | Typical price range |
|---|---|
| Attic inspection, air-seal survey, written scope | Free |
| Radiant barrier re-hang (Reflectix already present, intact) | $350 – $850 |
| Reflectix removal + replacement with solid radiant barrier | $900 – $2,200 |
| Air sealing (top plates, can lights, penetrations) | $600 – $1,400, varies by attic complexity |
| Blown-in attic insulation top-up to R-38/R-49 | $1,200 – $3,100 |
| Full Reflectix removal + rodent proofing + new system installed | $3,200 – $5,400 |
What moves the price: attic square footage, whether Reflectix has to come out, whether rodent damage needs proofing and sanitizing, number of can lights and penetrations, and whether you’re adding a radiant barrier on the roof deck in addition to the floor. We’ll give you the exact written price before any work starts, and if you have a competing estimate we’re happy to read it with you under our Free Second Opinion offer. Call (833) 630-4008 for a free estimate.
Why North Las Vegas Homeowners Call Envelope Insulation North Las Vegas for Reflectix Work

We’re independently owned and operated under The Haven Standard since 2016, and we’ve completed 9,000+ homes with the same discipline: written price before any work starts, documented record before we leave, before-and-after blower-door numbers published on applicable jobs. Our technicians have up to 10 years of experience and are background-checked and uniformed, and calls are answered by a live person 24/7 – no voicemail loop. Under Haven Standard: you get a named technician and a text when they’re on the way.
On Reflectix work specifically, that means we don’t tell you what we feel about your attic – we show you the CFM50 readings and the photos and let the number be the argument. And because we’re not locked to Reflectix, if your attic calls for Owens Corning AttiCat or Johns Manville fiberglass, that’s what we’ll spec. If you’re near Aliante, Eldorado, or the older tracts off Carey, you’ve probably got a neighbor we’ve worked for.
FAQs
Reflectix manufacturer warranty coverage generally depends on proper installation and product condition, and once a product is removed from the attic we can’t guarantee the manufacturer will honor an original warranty – though any covered material defect on new Reflectix product we install is passed through to you. What stays fully nailed down is our own written warranty and the 365-Day Done Right Promise on the labor. Call (833) 630-4008 and we’ll read our warranty with you before you sign anything.
Usually it can be repaired in place if the foil is intact and correctly installed – torn seams, staples, a wrong re-hang, or a missing air gap are all fixable for $350 to $850 in a typical North Las Vegas attic. It has to be replaced if the foil is brittle, torn beyond repair, or sitting over damaged or contaminated fiberglass, which pushes cost into the $900 to $2,200 range before insulation. The honest answer depends on what we see – and we always inspect in person before quoting. Call (833) 630-4008 to schedule the inspection.
Repairing existing Reflectix is cheaper in the short run, but if you’re relying on Reflectix as your only thermal layer, you’re getting about R-4 – nowhere near the R-38 to R-49 a North Las Vegas attic needs to keep up with a July afternoon. Most homes here end up doing both: keeping or reinstalling the Reflectix radiant barrier for the reflective benefit, and adding a properly air-sealed blown-in layer to do the thermal work. That combined approach runs $1,900 to $4,500 in a typical North Las Vegas attic. Call (833) 630-4008 for a written price.
We source Reflectix-compatible radiant barrier from standard building-supply channels and can usually have product on-site within a few days for a scheduled North Las Vegas install. Some specific Reflectix SKUs – particularly the wide 48-inch Double Bubble rolls – occasionally go on backorder, and if that happens we’ll tell you before we book you and offer a comparable solid radiant barrier from a brand we carry. Call (833) 630-4008 and we’ll confirm current availability for your attic.
Inspections are usually scheduled within a few business days, and full Reflectix jobs are typically on the calendar within one to two weeks once you’ve approved the written scope. Emergency situations (a rodent-damaged attic, a hot room with a failed install, water intrusion) get prioritized, and calls are answered 24/7 by a live person. Call (833) 630-4008 and we’ll give you the next available slot.
Written by the team at Envelope Insulation North Las Vegas, serving North Las Vegas and nearby areas.