Fast, Reliable Attic Air Sealing Across Henderson
If you live in Henderson and your upstairs rooms run hot no matter what you set the thermostat to, the problem is usually not your insulation depth. It’s the leaks. We seal the attic floor of Henderson homes so the 140°F air sitting above your ceiling stays there instead of soaking into your living space. We know this valley well, from Green Valley scuttle holes to the tight tile-roof attics out in Anthem, and we get crews out to Henderson fast. Call (833) 630-4008 for a free estimate with a written price before anything starts.
Why Envelope Insulation North Las Vegas Is Henderson’s Preferred Attic Air Sealing Company
Henderson homeowners research hard before they call, and we’d rather you did. What we put in front of you is documentation, not a sales pitch: a written scope, a written warranty, and a documented photo record of the work before the crew leaves. Every applicable job also gets before-and-after blower-door numbers – a pressurization reading that shows, in one figure, how much conditioned air the home was losing before we sealed it and after. That single number is the proof of what you paid for, and you keep it.
We operate under The Haven Standard, which means a flat written price before anyone lifts a tool (Clause 1), background-checked technicians, and a live person answering calls 24/7 instead of a voicemail loop. Bring us a competing Henderson estimate and we’ll read it with you as a free second opinion. That’s our 9,000+ sealed and insulated homes since 2016 talking – each one closed out with a written record and covered by the 365-Day Done Right Promise.
Our Attic Air Sealing Services in Henderson

Attic air sealing here is about correcting builder-grade shortcuts, not chasing drafts in old construction. Our Attic Air Sealing team works the four areas that leak most in Henderson’s 1990s – 2000s master-planned homes.
Attic Floor Air Sealing
We seal the penetrations and gaps across the attic floor itself before any insulation goes down. In Henderson’s master-planned construction, the floor is often pocked with unsealed wire holes and dried-out gaps that let hot attic air radiate straight down. We seal first, then insulate – never the other way around.
Top Plate & Penetration Sealing
Top plates and wire penetrations are routinely left unsealed in tract-built Henderson homes, and they’re the pathway for both radiant heat and dry desert air infiltration. We foam those joints so the wall cavities stop acting like chimneys. This is the kind of bypass that quietly undermines a fresh insulation job if nobody seals it first.
Can Light & Duct Boot Sealing
Unsealed can lights and duct boots in 1990s – 2000s homes leak conditioned air into a 140°F-plus attic, which forces your AC to work harder all summer. We seal around the fixtures and boots with methods that respect the heat the fixture throws off. If you’re seeing hot spots under recessed lights, this is usually why.
Attic Hatch Sealing
Builder-grade attic hatch gaskets shrink and tear in Henderson’s heat, and a torn gasket lets attic air pour straight into a hallway or closet. We replace and foam-seal the hatch so it closes tight against the frame. It’s a small, cheap fix that shows up clearly on the blower-door reading.
Trusted Brands We Service in Henderson
When sealing and insulation work together, the materials matter as much as the labor. We source from Owens Corning, GreenFiber, CertainTeed, Icynene, and Demilec, and we don’t lock you into a single proprietary product. If you already have one of these insulations in your Henderson attic, we work with what’s there rather than selling you a full replacement you don’t need. Turnaround is quick, and every sealed job still gets its photo record and blower-door numbers on the way out.
Common Attic Air Sealing Problems We See in Henderson Homes

- Shrinking attic hatch gaskets. Builder-grade gaskets shrink and tear in the valley’s extreme heat, letting 140°F attic air pour into hallways and closets. It’s one of the most common bypasses we find in Green Valley homes.
- Unsealed can lights and duct boots. In homes built during the 1990s – 2000s boom, recessed lights and duct boots leak conditioned air into a scorching attic, so the AC never gets ahead. Sealing them is often the single biggest blower-door drop.
- Open top plates and wire penetrations. Master-planned construction left many top plates and wire holes unsealed, creating a path for dry desert air infiltration and radiant heat transfer. A bright light in the attic often shows daylight where there shouldn’t be any.
- Settled fiberglass masking the leaks. Years of extreme attic heat settle and degrade blown-in fiberglass, so a fresh-looking insulation depth hides the bypasses underneath. That’s why we seal before we top off.
Pricing for Attic Air Sealing in Henderson, NV
Here’s what air sealing actually runs in Henderson, so you can plan before you call. A typical attic hatch seal with a new gasket and foam runs $180 – $340. Sealing can lights and duct boots across a standard master-planned home usually lands between $400 and $900 depending on how many fixtures are open. Full attic floor sealing with top plates and penetrations typically runs $1,200 – $2,600 for a 1990s – 2000s Henderson home. Cost climbs with the number of bypasses, attic access difficulty through tight scuttle holes, and whether radiant barrier work is added. Same-day estimates are free, and you get a written price before any work starts.
We Also Serve Cities Near Henderson

We bring the same sealed-first approach to homes around the valley, including Boulder City, Whitney, Paradise, and Enterprise. If you’re just outside Henderson proper, the same builder-grade bypasses show up in nearby 1990s – 2000s construction, and our Attic Air Sealing in Henderson team can scope it the same way. Wherever you are in the area, you get a written price and blower-door proof.
Serving Henderson, NV – Our Local Coverage Area
We serve Henderson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Attic Air Sealing in Henderson

Because builder-grade shortcuts, not insulation depth, are usually your biggest leak. Tract-built 2000s homes often left top plates, can lights, and hatch gaskets unsealed, so the insulation is sitting over holes. Sealing those first is what makes the insulation perform. Call (833) 630-4008 and we’ll show you on the blower-door reading.
In most Henderson attics, yes – sealing the bypasses matters more than adding depth. When attic temperatures push past 140°F, hot air and radiant heat find the unsealed leaks far more readily than they’re stopped by more fiberglass. R-value still counts, but sealing comes first. We’ll measure both before recommending anything.
The attic hatch and unsealed can lights are the two most common, followed closely by open top plates. Builder-grade hatch gaskets shrink and crack in the heat, and recessed lights leak unconditioned air straight into the attic. These are quick, affordable fixes that show up clearly on the before-and-after numbers.
In many Henderson homes, yes – we can often seal hatches, can lights, and accessible penetrations without a full removal. If fiberglass has settled and is hiding bypasses, we may recommend removal and replacement so the sealing is done right. The free estimate tells you which path your attic needs. Call (833) 630-4008 to schedule it.
Dry desert air means your leaks are about heat and air infiltration, not cold-weather moisture problems. With single-digit humidity and 100°F+ summers, an unsealed attic hatch or top plate lets scorching air into the house and radiant heat off sun-baked stucco walls. Sealing those paths keeps the cooled air where it belongs, which is why the blower-door number moves so much after a proper seal.
If your Henderson home is running hot upstairs or your AC can’t keep up, the fix usually starts in the attic with sealing, not more insulation. We’ll give you a written price, seal the bypasses first, and hand you before-and-after blower-door numbers so you can see the change you paid for. Call (833) 630-4008 for a free estimate – a live person answers 24/7.
Written by the team at Envelope Insulation Co.